Miscellaneous
General cannabis hemp cultivation information and discussions that don't have a particular forum.
2,888 topics in this forum
-
-
- 420 Crew
- 2 replies
- 708 views
hey. I've been planning my first grow for quite a while now... and have basically planned everything... just want to run ideas past the forum before doing anything..... I'll start with the strange parts first.... first up. I'd like to grow a pair of cannabis plants (not sure on strain yet) and one papaver somniferium.. Strains I've considered so far are: Marley's Colley Shiva Skunk Chronic Any suggestions? The main reason for this post is to ask the following questions: I've read that poppies and cannabis require similar conditions, will they be able grow together in the same heat, lighting and nute conditions? Which strains are recommended and where can…
Last reply by WantDaChronic, -
-
-
- 420 Crew
- 7 replies
- 931 views
Is my grow light close enough to my seedlings?It is a 250watt.They seem to have slowed down a bit the last 3 days.
Last reply by Pam, -
-
- 8 replies
- 1.2k views
I might need to adjust ph levels in my soil,im not sure.Heres the deal - The pic has 4 pots in it but i only have 1 seedling in one of the purple pots and one in the big brown pot(seedlings are only 13 days old).I have a soil ph tester with the probes on it from bunnings that says the ph in the brown pot is in between 6.0 and 7.0,so about 6.5.In the small purple pot its ph is about 7.1. I was under the impression that cannabis like neutral ph of 7.0ph but have read also that they like 6.0 to 6.5ph.So which is it? In the pic the 250watt light is really close but have moved it way up high now.Which is the best way to adjust the ph levels in my situation?Do i use fine dolomi…
Last reply by ktm250, -
- 7 replies
- 3.5k views
Just wondering if i should add some Co2 ENRICHA crystals when i water my plants.This one is on ebay- http://cgi.ebay.com.au/Hydroponic-Co2-Enri...1QQcmdZViewItem Should i use this on two week old seedlings in growbox? There are also these co2 tablets for aquariums could i use these?If i can can i just drop one tablet in a pot of water?Heres the link on ebay - http://cgi.ebay.com.au/Co2-Tablet-For-plan...VQQcmdZViewItem
Last reply by Pam, -
- 0 replies
- 764 views
1) what ph do i need the water to be in a bubbler cloner ? 2) is distilled water a good idea for a bubbler cloner? 3) what temperature is recommended for the water to be in a bubbler cloner? any other info on bubbler cloners be 'preciated too
Last reply by HippyStoner, -
-
- 420 Crew
- 11 replies
- 1.6k views
Well as the title and description says. Any ideas why this happens? For as long as i can remember this always happens to me. I get 5 or 6 buds grow out of the top of the main colas. Its like it goes into a sort of stretch stage. Where it then has to fill out again. Sorry about the bad quality pic doesnt show much. Here is a pick of my last grow you can see the buds growing out of the main cola head. Not sure if this is a good thing or bad thing. as long as i let the buds "fill out" it is ussually ok i think. Any suggestions why it does this ? Cheers Buddy.g
Last reply by moKing, -
-
Clones Dying
by Tuna-
- 420 Crew
- 7 replies
- 1.2k views
got some clones that were doing well, then they started to turn yellow, then brown shrivel up and die. Conditions are good. Why is this happening?.
Last reply by Luke Skywalker, -
-
I've been giving my lil' girl bottled water only, I was just wondering if there was a differnce betwen that and tap and if I might be doing her some harm... I water her every otherday, with Dasani, a Filtered drinking water produced by the Coca-Cola Bottling Corp.
Last reply by Ion, -
-
- 420 Crew
- 4 replies
- 880 views
As the title suggests..im just wondering how often i should water when ive mixed 30% perlite into my potting mix...its seems to be dryer alot quicker and bcause the perlite is mixed in...does that mean i can water even when the substrate is still slightly damp? any tips? Cheers, Flon
Last reply by flonmofo, -
-
How do you keep your airstones at the bottom of your bubblers and reservoirs, and stop them floating to the surface? Is there anything toxic in plywood (the glue maybe?) or is it okay to use, in the nutrient solution, to hold the airstones down? All replies appreciated! P.S. like my new Avatar?! Cugel.
Last reply by Luke Skywalker, -
-
- 420 Crew
- 2 replies
- 740 views
I planted my seeds (after leaving in damp tissue over night) about a quarter of an inch under the soil and as the light(250watt hps) was only about 6 or 7 inches above the soil it dried out the top layer of soil after 18hours of lights on and when i watered them to make moist again the water pushes the dry soil off a bit each time so that eventually the seed was very close to the top.Well yesterday i raised the light about another 3 inches higher and went to put the seed a little deeper in the soil but it had sprouted and i had the light on and the root got about 4 seconds of intence light before i coverd it up again. Is this going to be ok?Or would i have shocked it?Al…
Last reply by jimbojones5678, -
-
- 11 replies
- 1.8k views
I have finished setting up my growbox with 2 x 120mm sunon fans and they are too noisy.The box is made of plywood and i am ussuming that it makes the fans echo a bit.So i coverd the whole outside of the box with carpet to try and smother the noise a bit,but it hasnt worked very well if at all.I am very dissapointed as i cant have it this loud because of the neighboures.The box is in a 10x10 shed.Any help is greatly appreciated.
Last reply by Cugel, -
I have had my plant under 12/12 for 2 weeks now. I noticed yesterday that she is a female,...but she has red pistoles. It is only the lower part of the plant upper part has no pistoles yet. Is this a problem or stain related?? I can't quite get a good pic as my good Cam is getting fixed ATM. Any help very much appresiated. - BTW It is just a bagseed grow for my first go. In soil under 500watt cfl
Last reply by Ausbud, -
-
- 420 Crew
- 6 replies
- 1.5k views
G'day, Quick question.. when taking clones to sex, can you put the cuttings straight under 12/12 while they grow roots to sex as soon as possible? Or do they need to be under 24 hour light until they root, then 12/12 them till they show their sex? Because immediate 12/12 would have them showing sex in around 2 weeks, whereas waiting until they root and then sexing could take around a month.. but if they need 24 hour light to survive then I guess I have no choice And am I right in thinking you should wait until the plant has 5 nodes before taking cuttings? Or can you do it earlier? I want to determine sex with clones as early as possible... Cheers!
Last reply by bughouse loco, -
-
-
- 420 Crew
- 8 replies
- 958 views
Do my fans need to be on or off while the dark period is on?I ask this as i have a growbox in my shed that is powered by a extention cord coming from the house into the shed that is connected to a powerboard on top of my growbox that has two fans and a ballast with 250watt light connected to it.I have a timer pluged into the power point in the house then the extention cord pluged into that.So obviously when the timer goes off so do the fans.I think that makes sence,sry have had a fair few bourbons.I cant have anymore than one extention cord going to the shed as this would look very suss.I have my light and fans on for 14on10off.My seeds have been in the soil for 2 days.
Last reply by Al B. Fuct, -